Learn How to Ascend: Part 2, Setup - ITS Tactical
Shop the ITS Store!
 

Learn How to Ascend: Part 2, Setup

By The ITS Crew

Learn How to Ascend 06In this article we’ll be putting everything together and show how to connect the ascender setup to the rope.

Ascending  is arguably another one of the most dangerous procedures in climbing, so pay attention to your setup because an improper one can get you killed.

The reason it’s one of the most dangerous procedures is the fact that much like rappelling, it forces you to rely on your equipment and anchors 100%.

Let’s recap, ascending  FORCES YOU TO RELY ON YOUR EQUIPMENT AND ANCHORS 100%!

This is why learning knots and getting proper  training  is so important, because it could cost you your life.

OK, now that we have the warnings out of the way, let’s learn how to set up our ascent!

Inspection

In mechanical ascending inspecting your gear is paramount, and you’re relying on your equipment and anchors 100%.

At this point of the game there’s not much you can do to check your anchors, which are however many feet above you, but you can inspect your ascending equipment.

Inspect  everything that will be used in the ascent for fraying, wear, damage and anything else that might prevent its correct working operation.

Climbing Harness

When donning your climbing harness be sure to remember to lock in any loose ends with an overhand knot and have a buddy check you over to make sure everything looks right.

Here’s a video we made in our “Learn How to Rappel” series on locking the loose ends of the harness.

Black Diamond nForce Ascenders

Learn How to Ascend 07The first step in mounting your ascending equipment is to attach the Black Diamond nForce Ascenders  to the rope. Our preference is to attach the dominant hand ascender to the top, which in this case is the right ascender.

The nForce ascender cam opens two ways, you can squeeze the trigger to snake the ascender through a z-shaped pattern, or maneuver the black thumb release through the same movement.

To close the cam around the rope either depress the trigger or hit the black thumb release.

Learn How to Ascend 08After the ascenders are mounted, a locking carabiner should be placed in the top most hole to lock the rope in.

If the ascender were to suddenly open during ascent, the carabiner would prevent the ascender from detaching from the rope.

The purpose of using a locking carabiner here is that if the ascenders meet up on the rope, as they often do, the two top-most carabiners can lock into each other, preventing you from going anywhere.

Metolius Easy Daisies

Learn How to Ascend 09Once your ascenders are attached to the rope, it’s time to attach the Metolius Easy Daisies to your harness.

To connect the Easy Daisies, girth hitch the sewn loop end through the main attachment point of your harness.

After girth hitching both Easy Daisies, let them hang as you move on to the next step.

Metolius Easy Aiders

Learn How to Ascend 10The purpose of moving on to the mounting of the Metolius Easy Aiders, is that when attaching the daisies and aiders to the carabiners, the order matters.

Aiders must be attached through the locking carabiner first, followed by the daisies. This ensures that the daisies are mounted to the inside of each carabiner, or closer to you.

Take the aider attachment loop in one hand (ensuring the buckles face outboard) and a locking carabiner in the other. Come over the top of the outer non-structural release loop and insert the carabiner into the structural sling loop.

Rotate the carabiner all the way around the aider attachment loop to make room for the daisy the will be attached next.

Repeat the process with the other Easy Aider.

Putting it all together

Learn How to Ascend 11At this point you should have two locking carabiners with your Easy Aiders attached. Now you’ll simply repeat the process for attaching the Easy Daisies to these carabiners.

When you rotate the carabiner around the daisy attachment loop you should have the aider forward of the daisy (see photo, which shows the right hand aider/daisy setup)

Hook in

Learn How to Ascend 12Now that you have your Aiders and Daisies connected to their respective locking carabiners, we’ll attach them to the ascenders.

The great thing about the Black Diamond nForce Ascenders is that they make this attachment much easier.

Simply connect each carabiner to the 360 degree attachment points at the bottom of each ascender, and while holding the aider/daisy loops rotate the carabiner so that you “screw down, so you don’t screw up.”

Step in and adjust

Learn How to Ascend 13The last thing left to do is to step into the Metolius Easy Aider foot stirrups and cinch them up. With the way we’ve connected the buckle/adjustment portion of the Easy Aider, the stirrup adjustment will pull to the inside.

In our YouTube video we show some adjustments being made of the Easy Aiders and Easy Daisies right before ascending. We’ll cover this in more detail in our final article.

Check out our video below for a walkthrough of the setup.

Stay tuned for the conclusion of our “Learn How to Ascend” series next week!

For further information on the Black Diamond nForce Ascenders visit Black Diamond’s Web site at www.blackdiamondequipment.com

For further information on Metolius Easy Daisies and Easy Aiders visit Metolius’ Web site at www.metoliusclimbing.com

This information is provided solely as reference to supplement proper ascending training from an experienced guide, not replace it. Ascending is one of the most dangerous things you can do in climbing because you have to rely on your equipment and anchors 100%.

Did you get more than 14¢ of value today?

If so, we’d love to have you as a Crew Leader by joining our annual membership! Click the Learn More button below for details.

Thanks to the generosity of our supporting members and occasionally earning money from qualifying purchases as an Amazon Associate, (when you click our Amazon links) we’ve eliminated annoying ads and content.

At ITS, our goal is to foster a community dedicated to learning methods, ideas and knowledge that could save your life.

Discussion

Do you have what you need to prevail?

Shop the ITS Store for exclusive merchandise, equipment and hard to find tactical gear.

Do you have what you need to prevail? Tap the button below to see what you’re missing.